
CHERY A520 SERVICE MANUAL QR519 TRANSMISSION
21
DISASSEMBLY:
(1) Use a puller to pull out the rear output
shaft bearing and the 4th driven gear;
(2) Take out the 3rd-4th driven collar;
(3) Successively take out the 3rd driven
gear,
2nd
driven
gear,
1st/2nd
synchronizer
cone
ring,
out
synchronizer ring, inner synchronizer
ring and 2nd needle roller bearing;
(4) Use a snap ring plier to take out the snap
ring for 1st-2nd synchronizer gear hub
(as shown in Figure 33);
(5) Pull out the 1st-2nd synchronizer
assembly and remove the 1st driven gear
and 1st needle roller bearing;
(6) Pull out the front output shaft inner
bearing from the front end of output
shaft.
Figure 34
NOTICE FOR INSTALLATION:
(1) Clean all the components.
(2) In the same way as for the input shaft,
successively check the following items:
output shaft, needle roller bearing, 1st
driven gear, 2nd driven gear, and
1st-2nd synchronizer gear sleeve and
hub.
(3) Check the outer synchronizer ring, inner
synchronizer ring and synchronizer cone
ring:
①
Check whether there is any damage on
the tooth surfaces and conical surface.
②
Mount the outer and inner synchronizer
rings and put them into the state of
pressing on the respective gears, and
measure the values of clearance "A". If
the value of A is less than the
corresponding specified limit value, it is
Figure 35
Gear
Outer Ring
Cone Ring
Outer Ring
Cone
Ring
Inner Ring
Inner Ring
PDF created with pdfFactory Pro trial version
Summary of Contents for A21 2005
