Chery A21 2005, Service Manual, Page: 140 / 475

CHERY A520 SERVICE MANUAL CHASSIS
59
VI. MOUNTING OF THE FRONT
STABILIZER BAR ASSEMBLY
Serial
No.
Name of Spare
Parts
Quantity
1 Stabilizer bar
1 1
2 Extension bolt
1 2
3 Rubber pad
1 8
4 Metal sleeve
1 2
5 Nut
1 2
6 Clamp
1 2
7 Bolt
1 4
8 Rubber support
1 2
Put the rubber support sheath 8 onto the
stabilizer bar1, install the clip 6 onto the
rubber support sheath 8, and fix the central
part of the entire stabilizer bar assembly
onto the under-frame by use of bolt 7 with a
specified torque of 25
±
2m. The both ends of
stabilizer bar connect to the lower control
arm through an extension bolt with a
specified torque of 50
±
3m. The top and
bottom surfaces of the connection joint of
stabilizer bar end and lower control arm
have a rubber pad 3 respectively, and there
is a metal sleeve 4 between the second and
third rubber pads of either end of stabilizer
bar.
It is to be noted that all the rubber pads 3
are the same, but the top and bottom sides
of each rubber pad are different, of which
one side has a sulfurate metal pad, while the
other has no such a metal pad. Thus, the
each end of four rubber pads has obverse
and reverse surfaces in the case of
assembly.
Note: The four rubber pads of each end of
the stabilizer bar must be mounted
according to the sequence illustrated in the
figure.
The Side That Has A
Sulfurate Metal Pad
The Side That Has
No Metal Pad
PDF created with pdfFactory Pro trial version www.pdffactory.com