CF MOTO CF125T-19 2003, Service Manual

Page: 234 / 241

18Light, Instrument, Switch
18
18-13
Starting enriching device
System inspection
Note
Exhaust contains toxic contents. Do not
run the engine for a long time in a
closed or poorly ventilated place.
Note
Inspection should be done after the en-
gine is cooled down.
Unit inspection
Inspection of Resistance
The inspection of resistance can be
done without removing the carburetor.
Disconnect 2P coupler of starting enrich-
ing device.
Measure resistance between coupler ter-
minals
Standard value: 19.5-21.5
Ω
(20
℃
)
Inspection
Remove carburetor(5-3)
Connect ethylene pipe etc. to fuel increment loop
Check that when the carburetor is cold, there is
air current in the carburetor when blowing. The
fuel increment loop is fully open.
Connect the fully charged battery between cou-
pler terminals for 5 minutes.
There isn ’ t air current in the carburetor when
blowing
The fuel increment loop is fully closed.
If any fault found in the above inspection, re-
place the starting enriching device or check the
carburetor for blockage. (5-4)