CF MOTO CF125T-19 2003, Service Manual

Page: 217 / 241

17-2
CFMOTO
Starter relay
Notes
• Check and confirm battery is in good status
before inspection.
• In case of poor starting, check each brake
switch and starter relay. (Chapter 16)
Disconnect 4P coupler of starter relay and remove
starter relay.
Input voltage
Keep ignition switch in the ON position.
When holding front brake or rear brake, make sure
there is battery voltage between red/white (+) and
frame body earthing wire.
If there are any abnormals in the above inspection,
check ignition switch, brake switch, main fuse (15A),
secondary fuse (10A). If all these items are OK,
replace starter relay.
Earthing wire return circuit
Disconnect 4P coupler of starter relay and remove
starter relay.
Press down starter switch to check if the green ter-
minal of starter relay 4P coupler is well connected
with frame body earth wire.
If not, check the main cable for any break or short
circuit.