CF MOTO CF125T-19 2003, Service Manual

Page: 222 / 241

18Light, Instrument, Switch
18
18-1
Overhaul information 18-1 Brake light switch 18-8
Troubleshooting 18-2 Electrical horn 18-8
Bulb replacement 18-3 Odometer 18-9
Head light 18-5 Fuel sensor 18-10
Ignition switch lock 18-6 Water temperature sensor 18-12
Handlebar switch 18-7 Starting enriching device 18-13
Overhaul information
Notes on operation
Note:
• Headlight bulb has larger power and the temperature is very high when it si turned on. Do
not touch it after it is just turned off. Operation should be done when the bulb is cooled down.
• Inspection of water temperature alarm indicator may use fire source and liquid of high
temperature. Do not put flammable matters nearby and take care not to get burnt.
• The temperature of headlight is quite high when turned on. Replacing with bare hand or
stained glove on will cause oil stains on the glass cover which may form heat points and cause
deformation of glass and damage to bulb.
• Pay attention to the following points when replacing the bulb.
— -Do not replace the bulb when it is turned on. Keep ignition switch in the OFF position, and
replace after the bulb is cooled down.
— Replace the bulb with hands in clean gloves.
— Clean the glass with a piece of clean cloth dipped in alcohol in case of any oil stains on the
surface.
• If the inspection has to use battery, check first if the battery is normal.
• Test of switches can be done without removing the switches from the vehicle.
• After the inspecting and overhauling of each part, routing of cables and wires should pass
through the proper positions.
• For removal and installation of taillight and rear turning lights, refer to chapter 2.
Overhaul standard
Item Standard
Main 20A Fuse
secondary 2x5A 2X10A
Headlight (Hi/Lo) 12V-35/35W
Taillight/brake light 12V-21/5W
Turning light 12V-10Wx4
Odometer indicator 12V-1.7W
Light, bulb
Indicators 12V-3.4W