Ceyear 3656 Series, Quick Start Manual

Page: 17 / 53

Ready for Use
9
marker.
3 Measurement
You may create S parameter measurement trace and display in different
windows.
4 Menu Bar
Major menu of the analyzer process, including all functions of the
analyzer’s measurements. You may operate by mouse or touch screen.
5
Sweep
Control
Terminat, pause or carry on the sweep of current measurement trace.
6 Active Entry Input values required of current operation.
7 Stimulus Set up start frequence, stop frequence, and points of the actived trace.
8
Soft Key
Tool Bar
Every key on front panel has corresponding soft key menu and makes it
simpler to operate.
2.5 Rear Panel
This section describes rear panel of 3656 Series Vector Network Analyzer in details, as shown in
the following picture:
Figure 2-3 Rear Panel of 3656 Series Vector Network Analyzer
Descriptions of keys on rear panel are as follows:
Table 2-4 Description of Rear Panel
S/N Name Description
1 USB Port Used to connect keyboard, mouse or other USB devices.
2 LAN Internet Access 100/1000 BaseT Ethernet connecting port.
3 GPIB Port
In conformity with IEEE-488 standard and used for sending and
receiving GP-IB/SCPI commands through GPIB connector.
4 VGA Port Used in connecting VGA monitor.
5 10MHz Ref Output
BNC female connector. the analyzer outputs a 10MHz sine wave
signal
，
which can be as the external reference signal of another device.
The device can be phase-locked to the reference signal of the analyzer.
Output frequency: 10MHz±10ppm, output level: 10dBm±4dB.
6 External Trigger Output Analyzer outputs trigger signal with 5V TTL level after system is ready.
7 External Trigger Input
Analyzer triggers sweep via signal input by this connector. You may set
up level trigger and edge trigger in trigger menu.
Requirements of input
signal: -0.5V≤ low level ≤0.8V, 5 V≥high level ≥2.0V.
8 10MHz Ref Input
BNC Female Connector. You may input 10MHz external reference
signal, the measurement signal of the analyzer is automatically phase-
1. USB Port
2. LAN Internet
Access
3. GPIB Port 4. VGA Port 5. 10MHz Ref Output
6. External Trigger
Output
7. External Trigger
Input
8. 10 MHz Ref Input
9. Power Cable Receptor
10. Power Switch