Installation Guide for FibeAir IP-20C-HP
Page 156 of 204
Ceragon Proprietary and Confidential
Procedure
1 Before attaching the U-Bend, make sure that the U-Bend is already fitted with
bushings in both ports. The U-Bend should be supplied with bushings to seal
the RF.
2 Short U-Bends are connected between adjacent radio ports on the side closest
to the Pole Mount. Place the U-Bend so that the embedded #8-32 socket hex
screws are in line with the radio ports of the OCUs, as shown in the figure
below. Make sure the sealing gaskets supplied with the U-Bend are in place
before mounting the U-Bends.
Sealing Gaskets
1
Use 2.5 Nm Torque
