Installation Guide for FibeAir IP-20C-HP
Page 110 of 204
Ceragon Proprietary and Confidential
6 Attach the Radio unit to the Diplexer unit using the 8 M5 captive screws supplied
with the Radio kit. Position the Radio unit on the Diplexer unit so that the two
location pins mounted on the TRX ports of the Diplexer unit fit into the
corresponding holes in the Radio unit. Perform the fastening in diagonal fashion as
in the previous steps. The location pins are located on either the left of the upper
TRX port and the right of the lower TRX port or the right of the upper TRX port and
the left of the lower TRX port, depending on the frequency.
8 M5 Captive
Screws
Location
Pin
Location Pin
(Not Shown)
Location
Pin Hole
Location Pin Hole
(Not Shown)
7 Repeat steps 4-6 to attach the second Diplexer unit and the second Radio unit
to the other side of the Dual Coupler, Dual Splitter, or Dual Circulator.
8 Connect the Flexible Waveguide and Sealing Gasket supplied with the Flexible
Waveguide kit to the RFU-C Adaptor plate. Tighten the four screws supplied
with the Flexible Waveguide kit.
