Installation Guide for FibeAir IP-20C-HP
Page 141 of 204
Ceragon Proprietary and Confidential
6.22
AFR 1+0 Hub Site
In an AFR 1+0 configuration, a Multicore FibeAir IP-20C-HP unit is deployed at the
hub site and two FibeAir IP-20C-HP or IP-20S units are deployed in two tail sites.
The hub site utilizes a single FibeAir IP-20C-HP unit with two radio carriers. Each
carrier is in a link, via its own directional antenna, with a tail site that consists of a
FibeAir IP-20C-HP or IP-20S unit.
Note:
The links should be located so as to ensure that the two radio paths do
not cross.
The tail site unit is installed as a simple 1+0 configuration.
The hub site unit is installed as a remote mount configuration in which two
flexible waveguides are used to connect the two Remote Mount Adaptor ports to
an antenna. This chapter describes a hub site installation.
For standard interface antennas (six feet and larger), no OMT and no Circ./Circ.
Adaptor are used, and the flexible waveguides are connected directly to the
antenna flanges. For instructions how to connect the waveguides to the antenna
flanges, refer to the antenna vendor's documentation.
List of Items
Item
Description
Quantity
Marketing Model
1
IP-20C-HP Radios
1
See Section 2.4.1,
2
IP-20C-HP Diplexer Units
1
See Section 2.4.2,
3
Flexible Waveguide Kit
2
4
IP-20C-HP DC POLE MOUNT KIT
1
DXDH-RM-MOUNT-ADPT-
ff
5
Adaptor Remote Mount Kit
1
DXDH-RM-MOUNT-ADPT-
ff
From 6-11 GHz.
6
Circ./Circ. Adaptor
1
Per Antenna Vendor. Not used for standard
interface antennas (six feet and larger).
Required Tools
•
Metric offset hexagon key set
•
Metric wrench key set
•
Phillips #1, #2 screwdriver
