CC Systems CC Pilot XS All-Integrated, User Manual And Reference Handbook

Page: 22 / 57

User Manual and Reference Handbook for the CC Pilot™ XS
22
Panel Mount
There are two installation alternatives for panel mounting: front-mounted or rear-
mounted
.
With a front-mounted installation, use the rubber mask as a seal against the panel
plate. The unit is locked down by applying clamps which are either fixed to the panel
(recommended) or fixed to the unit through holes for VESA75 installation.
By replacing the rubber jacket on the unit with a cut-out rubber gasket, the CC Pilot™
XS can also be rear-mounted inside a suitable panel or equivalent. For this, the eight
fastening holes are used, see the figure below. As a fastener, appropriate machine
screws of type MRT M5 or MC6S M5 can be used. The maximum torque is 2.5 N-m.
If the surface against which the unit will be fastened is not flat, one must be careful so
that so that one does not expose the unit to mechanical stress due to tightening. This is
suitably solved through applying appropriate spacers between the unit and the surface
being attached to. As an alternative, a separate flat fastening plate can be used for the
unit. This is then attached with separate screws, or some type of fasteners, to the
panel. Use a thread locker in all screw holes, e.g.
Loctite 222
The drawing above illustrates the spacing of the eight mounting holes for panel
mounting from the rear. The drawings below show unit dimension, mounting holes
placement and cut out for display, buttons and indicators. For other dimensions please
see the section weight and dimensions.
Min
12 mm
The cap screws
should extend at
least 12 mm
beyond the
Panel Plate.
Panel
Plate
M5 Cap Screws,
8 pcs
.
Gasket