CC Systems CC Pilot XS All-Integrated, User Manual And Reference Handbook

Page: 10 / 57

User Manual and Reference Handbook for the CC Pilot™ XS
10
Connecting the Power Supply.
Status Indicating Function
On the front side of the CC Pilot™ XS there is a status indicator, a red LED, which is
used to indicate different states for your CC Pilot™ XS during start up.
A 1Hz flashing red light indicates that the unit is starting up normally.
A continuous red light indicates something is wrong.
A quickly-flashing red light means that the unit’s disc is blank and
needs to be loaded with an operating system.
When the operating system starts, the LED stops flashing. From the operating system,
the LED can be used to show more messages. For more information, refer to the
operating system’s manual and also to the respective manual for each program
installed.
Shutting-Down
To ensure that data does not get lost or the hard disk become corrupt, it is
recommended that all programs are closed before the unit is shut down.
There are three ways to turn off CC Pilot™ XS:
By pressing the On/Off button on the display.
By selecting Suspend on the start menu of Windows CE
By releasing the power connectors On/Off signal, i.e. using the turn key
functionality
When performing any of above the system will CC Pilot™ XS start to shut down. In
order to help prevent data loss when the CC Pilot™ XS is shut down, there is a safety
mechanism in the system, which prevents the unit from shutting off before data has
been saved. This requires that the software which is running supports this.
Forced Shut Down
If the computer is not responding, press and hold the On/Off button for five seconds in
order to perform a forced shut down off the onboard computer.
Note that any information which was not saved will now be lost.
Touch screen
The CC Pilot™ XS is fitted with a touch screen which gives the opportunity to provide a
very easy-to-use HMI (Human Machine Interface) for the user. The first time the touch
screen is touched will cause a calibration routine to run. If needed, Calibration can also
be started manually via the control panel: start
stylus , chose the tab Calibration and
then press the button Calibrate . Calibration can be cancelled by pressing the escape
key on a connected keyboard.
Be thorough with this calibration so that your touch screen will have the best possible
performance. You should use the same object (finger, stylus) during calibration which
you think you will use later.