Case 570NXT, Operator'S Manual, Page: 97 / 280

4 - OPERATING INSTRUCTIONS
STOPPING THE UNIT
Shutting down the engine
1. Before you leave the machine, make sure the machine is parked on a level surface. The machine must be on
level ground before you do scheduled maintenance.
2. Lower the loader bucket to the ground and if applicable the rear attachment.
3. Apply the parking brake and place the direction control lever in the Neutral position.
4. Run the engine at idle speed for two minutes (or more if the engine has been working at full load) to cool the engine
parts evenly.
NOTICE: Shutting down the engine when at a higher RPM than idle will damage the turbocharger.
5. Move the hand throttle to the Idle position and stop the engine.
6. Turn the key switch to the OFF position to shut down the engine. Remove the key.
Parking on a hill
WARNING
Unexpected machine movement!
The parking brake will not prevent this machine from moving if one wheel is raised above the ground.
Before raising one wheel above the ground, always block the front and rear of the other three wheels.
Failure to comply could result in death or serious injury.
W0193A
NOTE: If you must temporarily park the machine on a hillside, put the front of the machine toward the bottom of the
hill. Make sure the machine is behind an object that will not move.
4-9