Case 570NXT, Operator'S Manual, Page: 104 / 280

4 - OPERATING INSTRUCTIONS
Ride control (if equipped)
When ride control is activated, the loader down pressure is limited to the weight of the loader and the attachment
(bucket). The weight of the loader attachment is hydraulically cushioned during transport.
NOTE: Do not use ride control when the bucket is used in fine grading operations or when precision placement of a
load suspended from the bucket or other attachment is required.
Enable/disable
WARNING
Unexpected machine movement!
Stand clear of the loader arms. With ride control enabled and the key switch in the ON or ACC position,
the loader arms can drop slightly due to the hydraulic accumulator.
Failure to comply could result in death or serious injury.
W0177A
WARNING
Unexpected movement!
Stand clear of the machine. Activating ride control when the loader arm is applying down force, for
example supporting or lifting the front end of the machine off the ground, may cause the machine or
load to lower unexpectedly.
Failure to comply could result in death or serious injury.
W1163A
Before activating ride control perform the following actions:
• If equipped, place the hand throttle control at low idle.
• Only use the foot throttle.
• Down force is not being applied with the loader.
1. Lower the loader bucket to or near the ground line.
2. Press the emblem end of the rocker switch to enable
ride control. The emblem illuminates.
3. Press the opposite end of the rocker switch to disable.
The emblem no longer illuminates.
RAPH12UTL0089AA
1
4-16