Case 570NXT, Operator'S Manual, Page: 129 / 280

6 - WORKING OPERATIONS
Return to dig
After the bucket is dumped, use the return to dig feature to place the bucket in position for another dig cycle. Move
the loader control lever to the rollback position and the float position. The bucket roll backwards until the bottom of
the bucket is level and then stops. The loader arms will lower until the bucket reaches the ground or you manually
move the control lever to the neutral position.
RCPH10TLB006FAF
1
1. Bucket in float position
2. Bucket in rollback position
Adjust return to dig bucket position:
1. Park the machine on a level surface.
2. Apply the parking brake.
3. Lower the loader bucket to the ground and make sure
the bottom of the bucket is at the desired digging an-
gle.
4. Shut down the engine.
5. Loosen the adjusting bolts for the return to dig switch
and move the switch in the slot so that the roller on the
switch is resting on the edge of the cam on the loader
arm.
NOTE: When moving the switch bracket forward or
rearward for adjustment, be sure the bracket is pushed
in toward the machine as the bolts are tightened. This
will assure full contact of the switch with the actuating
cam.
6. Tighten the adjusting bolts.
RCPH10TLB257AAF
2
6-21