Car-O-Liner Group AB
Quick 42
60
40724, EN- rev. 8, 2017-09
4.7.1
Setup with chassis clamps
Depending upon the type of vehicle and the nature of the damage, the hy-
draulic jacks shall be placed under a strong part of the body.
Unibody
The recommendation is to lift the vehicle with a pair of jacks at the front un-
der the suspension cradle and then repeat the same procedure at the rear.
Full frames
(Vehicles with separate frame)
Suitable lifting points are on the frame of a vehicle with a separate frame.
The front or rear axle beams or corresponding structures are also suitable
lifting points.
1
Mark the gripping points A and B for the chassis clamps. The
measurements are given in the data sheet, see the instruction manual
for the Measuring System. Clean under-seal and dirt from the sill
edge to give the chassis clamps a good grip and to ensure that the
correct height is obtained when measuring.
2
Raise the lift to its highest position and fit the two hydraulic jacks.
3
Adjust the position of the hydraulic jacks for a suitable lifting point.
Remove the ramps where the hydraulic jacks are to be positioned
for easy access.
4
Tighten the hydraulic jacks.
