Quick 42
Car-O-Liner Group AB
40724, EN - rev. 8, 2017-09
59
4
Drive or winch the car on to the bench. Before drive on to the
bench make sure width positions of the ramps are fitted to wheel
track of the vehicle. Apply the hand brake.
5 Place the car lengthwise depending of the damaged area. Try to
position the vehicle’s centre line as closely as possible to the centre
line of the bench.
6 Lift the vehicle up to the desired working height.
NOTE
! Drive-off stop prevent the vehicle to roll off.
WARNING
! Block the wheels or engage the hand brake before tilting the
bench. Risk of unintentional rolling.
WARNING!
During setup of the vehicle on the bench, care must be
exercised so that the vehicle does not roll or slide out of the hydraulic jacks
or bench mountings. Risk of crushing injuries.
4.6
Setting up the vehicle
IMPORTANT!
Tightening torque
for
M16
nuts and bolts on bench
mountings (cam locks), chassis clamps, and EVO system is maximum of
200 Nm to avoid damage to the equipment.
IMPORTANT!
All nuts and bolts shall be cleaned and greased regularly.
Winch
