Car-O-Liner Group AB
Quick 42
26
40724, EN- rev. 8, 2017-09
3.2.8
Hydraulic Jacks Q170, 2 pcs
The hydraulic jacks are fitted to the bench tracks and used to lift a vehicle
during the setup in the bench.
WARNING!
Make sure to lift on a safe lifting point, so that the vehicle
doesn’t slide on the jack-pads during the lift.
WARNING!
Maximum static load per hydraulic jack = 900 kg (2 000 lbs).
NOTE!
Make sure the Cam lock is fully rotated before it’s locked with the
handle.
NOTE!
The jacks shall only be used for jacking the vehicle during setup.
3.2.9
Chassis Clamp B106
The B106 Chassis Clamp is bolted to the bench mounting arm and is provid-
ed with toothed segments that grip the vehicle’s sill edge.
The toothed segments may either be fastened to the clamp’s angle or to the
mounting plate. Alternatives for various vehicles are listed on the data
sheets.
The fastening holes are also offset so the segments can be turned if there are
obstructions on the sill flange.
The accompanying illustration shows a toothed segment fitted to the base
bracket.
Special chassis clamps are available for some vehicles. Consult the
Car-O-Liner data sheet for a list of vehicles concerned.
3.2.10 Sill Support B23
Used to avoid damage to the sill edge when setting up the vehicle.
