Quick 42
Car-O-Liner Group AB
40724, EN - rev. 8, 2017-09
47
4 Operation
4.1 General
WARNING!
During setup of the vehicle on the bench, care must be
exercised so that the vehicle does not roll or slide out of the supports or
mountings. Risk of crushing injuries.
The vehicle may be driven onto the ramps or winched up if there is wheel
damage.
The vehicle is lifted free of the ramps with the help of hydraulic jacks allow-
ing the bench mountings and chassis clamps to be fitted.
Depending upon the type of vehicle and the nature of the damage, the hy-
draulic jacks shall be placed under a strong part of the body.
The recommendation is to lift the vehicle with a pair of jacks at the front
under the suspension cradle, and then repeat the same procedure at the rear.
Proper weight distribution
Minimum allowed distance between the heaviest axle (normally the front ax-
le) and the run-up end is 0.5 meter when lifting a vehicle with short wheel-
base (1.5-2 meter).Otherwise there is a risk of tipping of bench in mobile use
which can cause crushing injuries.
