Car-O-Liner Group AB
Quick 42
56
40724, EN- rev. 8, 2017-09
4.5 Connect the Q16 to the benchframe
1
The head of the drawbar must be horizontal. The wedge (B) and
safety plate should hang straight down with the drawbar pushed
against the safety plate (A). The supports legs of the bench frame
must be adjusted so that the head of the draw aligner is free when
the draw aligner is pushed in under the bench frame.
WARNING
! Before moving the draw aligner, always lock the arm in an
upright position. Risk for tipping.
2
Rotate the drawbar 90
0
by drawing up the locking wedge and
safety plate. Turn the safety plate back again while holding the
wedge in its horizontal position. The drawbar and its head are
thus pressed against the inner side of the bench frame and the
head of the drawbar engages the steel strip on the inside of the
bench.
WARNING
! Always use safety glasses when hammering the locking wedge
in or out. Risk for splinters.
3
The draw aligner is locked to the bench frame by driving in the
locking wedge with a lead hammer.
4
The draw aligner is detached by performing the preceding steps in
reverse order.
WARNING
! Never release the locking wedge if the bench is not at draw
aligner height. Risk for injury.
A
B
