Canon Saddle Finisher-AF2, Service Manual

Page: 41 / 244

Chapter 2
2-15
F-2-48
6) Close the front cover of the finisher.
7) Move the latch mount (rear) [1] in the direction of the arrow and insert it
to the pin to fix it.
- 1 screw [2] (use the screw removed in step 7) "Before Installing the
Finisher")
F-2-49
8) Fix the cable [1].
- 2 Reuse band [2]
- 2 spots Edge Saddle [3]
F-2-50
9) Insert the connector [1] to the finisher controller PCB, and fix the cable
[2].
- 3 wire saddles [3]
F-2-51
10) Check the height between the finisher [1] and the Paper Folding Unit [2].
F-2-52
11) Install the rear cover.
12) Install the shunt cable [1].
- 2 screws (RS tightening; M4X10) [2]
[2]
[1]
[1] [2]
CAUTION:
Height difference should be /-2mm. Execute "1.4.1 Height
Adjustment" if the difference is +/- 2mm or more.
[1]
[2]
[3]
[3] [2]
[1]
[1] [2]