Canon Saddle Finisher-AF2, Service Manual

Page: 151 / 244

Chapter 4
4-41
F-4-183
11) Remove the C ring [1] and gear [2].
F-4-184
12) Remove the C ring [1], ball bearing [2] located in the rear side of the sad-
dle unit.
F-4-185
13) Move the shaft [1] on the front side of the folding roller (lower) to the
upper side of the hole.
F-4-186
14) Remove the folding roller (lower) [1] as the direction of the arrow.
F-4-187
4.5 Electrical System
4.5.1 Feed Motor Driver PCB
4.5.1.1 Preparation for Removing Feed Motor Driver PCB
0021-4901
1) Remove the rear cover. (page 4-2) Reference[Removing the Rear Cover]
4.5.1.2 Remove the Feed Motor Driver PCB
0021-4902
1) Remove the feed motor driver PCB [1].
- All the connected connector
- 6 screws [2]
F-4-188
4.5.2 Finisher Controller PCB
4.5.2.1 Finisher Controller PCB
4.5.2.1.1 Preparation for Removing Finisher Controller
PCB
0020-8795
1) Remove the rear cover.
(page 4-2)
Reference[Removing the Rear Cover]
4.5.2.1.2 Removing the Finisher Controller PCB
0020-8797
1) Remove the finisher controller PCB [1].
- All the connected connector
- 4 screws [2]
[1]
[1]
[2]
[2]
[1]
[1]
[1]
[1]
[2]
[2]