Canon Saddle Finisher-AF2, Service Manual

Page: 196 / 244

Chapter 5
5-34
F-5-151
5) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
F-5-152
6) Press switch SW385 [1] so that this adjustment is ready now.
F-5-153
7) Pressing push switch SW384 [1] twice displays "+2" on the LED [2].
F-5-154
8) Press switch SW385 [1] again to complete this adjustment.
F-5-155
5.3.2.23 Adjustment in the Case of Failure in Stacking
Performance of Tray (run-on of paper when using
thin paper)
0021-1731
Execute this adjustment in the case of failure in stacking performance of the
tray when using thin paper as shown in the figure below or replacing EEP-
ROM (IC107) on the finisher controller PCB.
F-5-156
Following describes the detailed adjustment method:
1) Turn ON the power of the finisher.
2) Turn ON the power switch of the host machine to be on standby.
3) Open the front cover and put the door switch tool into the door switch [1].
[2]
[1]
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]
MEMO:
Executing this adjustment makes the finisher to reduce feeding speed of the
paper.
This operation improves abovementioned failure in stacking performance
of the tray because of reduced curl-level with thin paper.
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]
[2]
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]