Chapter 7: Operation
System statistics
Page 7-74
Figure 257 Diagnostic Plotter page (HCMP topology)
Procedure:
•
Only on a device configured as in HCMP topology as a Master, set the Wireless Interface
Selector to the Wireless Interface the diagnostic data needs to be displayed for. Note the
Remote MAC Address indicated the MAC address of the unit currently connected, I any, to
the selected wireless interface.
•
Select a diagnostic from the Diagnostics Selector drop-down list. These are the same as the
System Histogram attributes in the System Statistics page (
) plus those listed in .
•
Tick the required Trace Selection boxes: Max, Mean and Min.
•
Update the Page Refresh Period as required. The default period is 3600 seconds (1 hour).
To monitor the performance of a link in real time, select a much shorter period, for example
60 seconds.
•
Click Plot Selected Diagnostic. The selected diagnostic trace is displayed in the graph.
Maximum values are displayed in
red
, mean values are displayed in
purple
and minimum
values are displayed in
blue
.
Table 230 Diagnostic Plotter specific System Histogram attributes
Attribute
Meaning
Tx Link Capacity
Utilization
The Tx Link Capacity Utilization measures the percentage of the
instantaneous transmit capacity actually uses to carry traffic. Note that this
percentage is relative to the instantaneous capacity of the link in the transmit
direction and that this capacity is dependent over time of the modulation the
link operates in.
