Bürkert 8619 multiCELL WM AC, Operating Instructions Manual

Page: 125 / 194

• A "Warning" event is emitted and the message "M0:W:Pulse x lim." is displayed when the volume
entered multiplied by the K factor of the device > 1,000,000.
• A "Warning" event is emitted and the message "M0:W:Pulse x 1:1" is displayed when the volume
entered multiplied by the K factor of the device < 1. In this case, the pulse frequency is forced to the
value of the input frequency.
8.10.24 Setting the parameters of an Ethernet module
Checking the IP address of an Ethernet version
Before installing an Ethernet version to the network, make sure the IP address of the device type 8619 is
not already used by another equipment.
→
If necessary, change the IP address of the device.
Refer to section 8.9 to access the "Parameters" menu.
This is
when the
device is be-
ing parame-
tered............
....................
This is
when the
device is be-
ing parame-
tered............
....................
M1: Ethernet
IP Address
Protocol
Parameters
EtherNet/IP
Modbus TCP
PROFINET
ENTERING
Gateway ENTERING
Netmask ENTERING
BOOTP
DHCP
DCP
DHCP+BOOTP
Manual
MAC Address READING
only if software option "ETH. protocols"
is activated. See section 8.10.4
if "Protocol" = "Modbus TCP" or
"EtherNet/IP"
Ethernet units
°C - L/min
°F - GPM
°C - ImpGPM
PVN1...PVN20
Format
Unit
List of units
Manual entry
0 / 0.0 / 0.00 / 0.000
ENTERING
IP settings Mode
if "manual" is
activated
Device name ENTERING
if "Protocol" = "PROFINET"
if "Protocol" = "PROFINET"
Read only if "IP settings" ->"Mode" = "DCP"
READING
if "Protocol" = "Modbus TCP"
125
Adjustmentandcommissioning
Type 8619
English