Bürkert 8619 multiCELL WM AC, Operating Instructions Manual

Page: 43 / 194

7.2 Installation procedure
1. To carry out mechanical installation: Depending on the version, follow the instructions in section 7.2.1 or 7.2.2.
2. To wire the device: Depending on the version, follow the instructions in section 7.3.
7.2.1 Installing a 8619 multiCELL on an enclosure or electrical
cabinet
→
Follow the instructions below to mount the device, delivered fully assembled, onto an enclosure or cabinet.
5
10
5,5 5,5
92 +0,5/-0
92 +0,5/-0
This diagram is not to scale.
The dimensions are given in mm.
Step 1:
→
Check that the thickness of the door of the enclosure
or cabinet is less than 4 mm.
→
Ensure there will be sufficient space around the cut
out hole and on the inside of the cabinet to easily
accommodate the 4 fasteners.
→
Cut a hole in the door of the enclosure or electrical
cabinet according to standard CEI 61554:1999 (DIN
43700).
Body
Screw
x4
Step 2:
Prepare the 4 fasteners:
→
Insert a screw into each device.
→
Tighten the screw until the end of the shaft of the
screw is flush with the device.
Step 3:
→
Slide the housing into the cut-out with the connectors
to the back, until it can go no further.
1
2
Step 4:
→
Insert (1) the hooks on the first fastener into the slots
on the housing.
→
Pull the fastener (2).
43
Installationandwiring
Type 8619
English