Bürkert 8619 multiCELL WM AC, Operating Instructions Manual

Page: 127 / 194

8.10.25 Setting the parameters of a pH/redox module
Refer to section 8.9 to access the "Parameters" menu.
if "Temp. calib" = "Manual"
This is
when the
device is be-
ing parame-
tered............
....................
This is
when the
device is be-
ing parame-
tered............
....................
Mx:pH/ORP
Temp. adjust
RTD
Temp. calib
Parameters
PT100
None
PT1000
ENTERING
Calibration limits
Warning low:
Warning high:
Error low:
pH zero
Temperature Auto
Manual
Auto
Manual
Buffer Hamilton
DIN19267
Error high:
ENTERING
ENTERING
ENTERING
ENTERING
Warning low:
Warning high:
Error low:
pH slope
Error high:
ENTERING
ENTERING
ENTERING
ENTERING
Warning low:
Warning high:
Error low:
ORP Offset
Error high:
ENTERING
ENTERING
ENTERING
ENTERING
°C
ENTERING
°C
ENTERING
if "Temperature" = "Manual"
if "Temperature" = "Auto"
RTD : Choose the type of temperature sensor connected to the module.
TEMPERATURE
: Choose the value of the temperature used in the process (particularly to compensate for the pH
measurement):
• choose "Auto": the temperature of the fluid is measured by the sensor.
• choose "Manual": enter the value of the process temperature (in °C) in the next field, e.g. when no temperature
sensor is connected to the module.
ADJUST TEMP.
: The measured temperature can be corrected by an offset value. Enter the offset value in °C.
TEMP. CALIBRATION : Choose the value of the temperature used when calibrating the probe/sensor:
• choose "Auto": the temperature of the fluid is measured by the sensor.
• choose "Manual": enter the value of the calibration temperature (in °C) in the next field, e.g. when no temper-
ature sensor is connected to the module.
127
Adjustmentandcommissioning
Type 8619
English