18
Stand-Alone Camera Section
Questions? Contact us at [email protected] or call (866) 325-8172
18
Questions? Contact us at [email protected] or call (866) 325-8172
1.
Turn the Camera on.
2.
Press the MENU button.
3.
Press the DOWN button once to display the Firmware
Version. If the version is 298 or higher, the Camera
has the Stand-Alone feature. If the version number is
below 298, contact BuckEye Cam at (866) 325-8172 to
learn more about updating the firmware.
D. Camera Settings in Stand-Alone Mode
Once you have switched the Camera into Stand-Alone
Mode, the first thing you need to do is insert a SD Card
into the Memory Card Slot. Now follow the instructions on
page 20,
Changing the Camera Settings with a Portable
Base
.
NOTE: If the Camera was previously used in the Wireless
Mode, the Camera Settings will remain the same when
switched to Stand-Alone Mode.
When the Camera is switched back to Wireless Mode, the
Camera Settings revert to the factory defaults.
9.
Portable Base
A. Adding a Camera to a Portable Base
When a Portable Base and Cameras are purchased
together as one set, cameras are already programmed
(registered) to communicate only with that particular base
unit. If an additional camera is purchased, it must be
registered with the base unit. Up to 14 cameras can be
registered with one base unit. During registration, the
base unit tells the camera what channel, address, and
camera number it should use. Also the base adds the unit
to the list of active cameras.
NOTE: Only add one camera at a time to avoid possible
communication errors. Turn on the power to the Portable
Base before you complete the following steps.
1.
Turn on the power to the Camera you wish to add to
the Portable Base.
If you are wanting to add more
cameras, only turn on one at this time.
Summary of Contents for RC-5000
Page 40: ...l l l l l 0 0 0 0 0 ...