btsr IS3, Operating Manual

Page: 52 / 71

Operating
- 3.38 - SMART 3000TW
Press to select the next sensor and check that the Red LED of the selected
sensor is flashing. Repeat this test on all connected sensors.
Press to move to the next function (TEST_BA) or (COM_B01).
COM_B01: Testing the Efficiency Rate over the
Communications Line between the SMART 3000TW
terminal and all sensors connected to the various
Boards
This function allows to check the perfect operation of the communications line
between the
SMART 3000TW terminal and sensors connected to the individual
Boards.
It is suggested to run this check during the first testing phase
(immediately after
installation) and each time random problems occur in the system operation, which
may have been caused by inefficient communications between the sensor and the
terminal
(for example: ERROR Dxxx).
From this moment on, the system communicates repeatedly with all connected
sensors. The test running status is signalled by the flashing red LED embedded in
the ENTER button. If there are no communication errors detected, the display
shows the message COM_B01 000/000. If communication errors are detected, the
display shows the message COM_B01 XXX/YYY, where the XXX indicates the
total number of failed attempts and YYY indicates the total number of sensors
where some problems occurred.
Press to check the communication with Board 02 and so on for all
connected Boards.
Press to move to the next function TEST_BA.
TEST_LP: LAMP 485 Devices Test
This function is enabled only if you activated the Priority Bars function on P2
menu, and it allows you to check the communication between
SMART 3000TW
and (one by one) the LAMPS 485 devices connected to the Boards. In this way you
can check that:
• All the LAMP 485 devices are correctly numbered and identified
• All the Devices respond correctly to the terminal
• The same number has not been assigned to more than one Device within the
same Board.