btsr IS3, Operating Manual

Page: 40 / 71

Operating
- 3.26 - SMART 3000TW
Individual sensor replacement example
If you replace a defective sensor, you will have to re-number the new sensor by
operating as follows:
When the NUMBER DEVICE screen appears, press to start the sensors
numbering procedure.
When the DEVICE BOARD 01 screen appears, press only if the replaced
sensor was connected to the Board 01; otherwise press until the Board# to
which the replaced sensor was connected.
At this point, press to proceed with the re-numbering operation of the
involved sensor.
Press to continue.
Press until the field mmm will show the actual number of the replaced
sensor (i.e. the sensor that must be re-numbered).
With a finger skim the “Touch Light” area of the replacing sensor and check that
the sensor LED goes from flashing green to red.
The replaced sensor will now be renumbered with the same number of the old
sensor.
When the numbering phase is complete, the system will automatically move to the
NUMBER LAMPS function (providing that the Bars priority is currently active in
menu P2) or to the KEY_COD function. In any case, press twice to resume
the CONTROL function.