btsr IS3, Operating Manual

Page: 39 / 71

Operating
SMART 3000TW - 3.25 -
NUMBER LAMPS: Numbering of LAMP 485 Devices (Optional)
When all sensors connected to all Boards have been numbered, the NUMBER
LAMPS screen appears (providing that the Bars Priority is active in menu P2).
Press to start the LAMP 485 devices numbering.
Press to continue without performing the devices numbering.
Press to number the bars connected to LAMP 485 devices 01.
Set the number of LAMP 485 devices connected to Board 01.
Allowed values: [001 ÷ 030].
Press to increase nnn
Press to decrease nnn
When nnn corresponds to the number of Devices actually connected to Board 01,
press to start the numbering sequence.
This screen indicates that the phase of automatic LAMP 485 devices numbering is
starting:
nnn = shows the total amount of devices to be numbered
mmm = shows the number of the first device (and subsequently the next one) to be
numbered.
! Check that the LAMP 485 devices on top of all bars is flashing green, to
indicate the “Bar ready to be numbered” condition.
Press the button of LAMP 485 devices to which you wish to assign the number
shown by mmm and check that:
a)
The signalling lamp changes from flashing green to steady green
b) The number mmm is increased by 1 unit.
Repeat the operation on all LAMP 485 devices connected to the Board 01.
When the numbering of all devices connected to Board 01 is completed, the
LAMPS BOARD 02 screen will appear.
Repeat the procedure described for numbering of Board 01, until you complete the
numbering of all devices.
When the numbering phase is complete, the system will automatically move to the
next function
(KEY_COD).