BTR DG-Mini, Manual

Page: 63 / 71

BTR Controls, Inc
TROUBLESHOOTING
DG-Mini V7 Rev. C Standard HW manual V 1.0.2 63
Table of Error Codes
Error
Code:
Description Level Cause: Check:
E24
SeyWave Internal
Failure
Fault Specific
Seywave Wireless
internal Fault Contact factory, this is not a
user-serviceable item.
E25
Hand Crank Active Fault Specific Hand Crank Active
This is a normal error when the
Hand Crank input is active. If
not cranking the door, verify
that the crank is in position,
verify that the switch is
functional, check wiring
connections.
E26
Door Overtravel High Priority Door Over Travel
E27
Photoeye Test Fault Medium Priority Photoeye Test Fault
Check that test signals are
connected correctly
E28
Photoeye 1 Activated Low Priority Photoeye 1 Activated
Normal message if the
photoeye is active. Otherwise
check alignment and wiring.
E29
Photoeye 2 Activated Low Priority Photoeye 2 Activated
Normal message if the
photoeye is active. Otherwise
check alignment and wiring.
E30
Input Timer Exceeded Medium Priority Input Timer Exceeded
Check for stuck input, such as a
pushbutton, that has been
activated for too long.
E31
Breakaway Active Medium Priority Breakaway Active
Jog the door to the breakaway
position and then press the
CLOSE button.
Error Code Priority Levels
Priority Level
Reset Condition Comment
Low Activation Input Can also be reset by higher priority
reset conditions.
Medium Stop, Monitored Stop or MENU/ENTER
Button pressed Can also be reset by higher priority
reset conditions.
High
MENU/ENTER Button pressed
Fault Specific Auto-clears when fault no longer
exists.