BTR DG-Mini, Manual

Page: 58 / 71

BTR Controls, Inc
QUICK
SETUP
DG-Mini V7 Rev. C Standard HW manual V 1.0.2 58
QUICK SETUP
The Quick Setup procedure is a required step during the installation of the DG-Mini. A Quick Setup must be
performed after all connections and programming, including profile selection, have been completed.
The Quick Setup is used to set door positions and also validate the installation. If the Quick Setup encounters a
problem it will abort and provide a corresponding error message. The error must be addressed before repeating
a Quick Setup.
Performing a Quick Setup is the only way to clear an E17 “Reset Limits” error.
Follow the steps shown below and the on screen instructions to perform a Quick Setup.
Screen Shots
Step: Display screens: Action:
1
Use the UP and DOWN Buttons to
move the door to near the center of
travel.
Note: The door may travel in the
opposite direction of the button
pressed. This is okay and is
corrected in a later step.
Press
ENTER when finished.
2
Press and hold the UP Button until
the door stops automatically.
3
When the door has stopped, follow
the on screen prompts to confirm
the door’s travel direction.
Incremental encoder (Not shown):
If you are using an incremental
encoder the controller will now
perform a reference run to
establish the reference location.
Follow the on screen prompts.
4
Using the UP or Down Buttons
move the door to the desired Fully
Open position.
Press Enter to store.
5
Note: This step may be skipped as
not all profiles require a
Breakaway position.
Using the UP or DOWN Buttons
move the door to the desired