BTR DG-Mini, Manual

Page: 28 / 71

BTR Controls, Inc.
PROGRAMMING
DG-Mini V7 Rev. C Standard HW manual V 1.0.2 28
PROGRAMMING
I
DLE SCREEN
Example 1
Example 2
The Idle (or home) screen is displayed during normal operation when no errors are present and
when not in a menu.
The display is divided into the following three sections:
Top
Notifications:
Displays non-critical information such as the cycle count and provides a quick
overview of the system using icons.
Middle
State:
Displays the current state of the controller or an active event timer. See the table
below.
Bottom
Event:
Displays a message corresponding to an event such as an input activation. The
message is displayed briefly for a momentary event or for the duration of a
maintained event.
Controller States
Display: Description
OFF Door controller is disabled.
IDLE
Door is stopped but not at a defined position. (Such as Partial 1, Partial 2 or Fully Open )
FIND REF Door must perform a reference run.
LOCKED Door is locked and cannot operate until the lock signal removed.
JOG Door is in operating in Jog mode.
CLOSED Door is at the Fully Closed position.
CLOSING Door is closing.
OPEN Door is at the Fully Open position.
OPENING Door is opening.
PART 1 Door is at the Partial 1 position.
PART 2 Door is at the Partial 2 position.
E
RROR
S
CREEN
When an error is present the idle screen is replaced by a screen showing the error code and a
description of the error. See the section on troubleshooting for further details.