BTR DG-Mini, Manual

Page: 40 / 71

BTR Controls, Inc.
PROGRAMMING
DG-Mini V7 Rev. C Standard HW manual V 1.0.2 40
Safety Edge
An activation of this input during a closing cycle will cause the door to stop motion
and then reverse to the Fully Open position. This will also cause an E10 error “Safety
Edge Activated”.
Photoeye 1
An activation of this input during a closing cycle will cause the door to stop motion
and then reverse to the Fully Open position. This will also cause an E28 error
“Photoeye 1 Activated”.
Lock Open
Activation of this input will cause the controller to hold the door at the Fully Open
position. The input must be continually activated to hold the controller in the Locked
state. A deactivation of this input will unlock the door and allow normal operation.
Lock Close
Activation of this input will cause the controller to hold the door at the closed
position. The input must be continually activated to hold the controller in the Locked
state. A deactivation of this input will unlock the door and allow normal operation.
Open Jog
Continuous activation of this input will move the door in the open direction at Jog
Speed. A deactivation of the input will stop motion of the door.
Close Jog
Continuous activation of this input will move the door in the Closed direction at Jog
Speed. A deactivation of the input will stop motion of the door.
Breakaway
Activation of this input will stop motion of the door. This will also cause an E31 error
“Breakaway Active”. A Breakaway reset procedure will be required. See the Trouble
Shooting section for details.
Open Part 1 Activation of this input will open the door to the Open Part 1 position.
Open part 2 Activation of this input will open the door to the Open Part 2 position.
Auto 1 Part 1
Activation of this input will open the door to the Open Part 1 position. The controller
will then delay the door for the duration of the Auto 1 Timer. Upon expiration of the
timer the door will close to the Fully Closed position.
Auto 1 Part 2
Opens the door to the Partial 2 position and starts the Auto Close Timer. Activation of
this input will open the door to the Open Part 2 position. The controller will then
delay the door for the duration of the Auto 1 Timer. Upon expiration of the timer the
door will close to the Fully Closed position.
Photoeye 2
An activation of this input during a closing cycle will cause the door to stop motion
and then reverse to the Fully Open position. This will also cause an E29 error
“Photoeye 2 Activated”.
Man 1 Part 1
Activation of this input will open the door to the Open Part 1 position if the door is
not at this position. If the door is already at or above this position the door will close.
If the Man 1 Timer is greater than zero, the controller will delay the door for the
duration of the timer. Upon expiration of the timer, the door will close to the Fully
Closed position.
Man 1 Part 2
Activation of this input will open the door to the Open Part 2 position if the door is
not at this position. If the door is already at or above this position the door will close.
If the Man 1 Timer is greater than zero, the controller will delay the door for the
duration of the timer. Upon expiration of the timer, the door will close to the Fully
Closed position.