7. USING THE SEWING MACHINE (OPERATION PANEL: ADVENCED OPERATION)
RH-9820
65
7-6. Manual sewing (manual mode)
CAUTION
The hammer may operate during manual mode, so do not put your hands near the hammer at this time.
If care is not taken, injury may result.
You can turn the upper shaft pulley by hand to move the feed base one stitch at a time. This is useful to do when adjusting the
spreader timing. (Refer to “9-10. Adjusting the spreader timing”.)
1
Switch the mode to manual mode.
The sewing shape (1), program number (2), cutting
operation (3), total number of stitches (4) and number of
stitches remaining (5) will appear in the display.
2
Select the desired program number (2).
The program number (2) changes in the order shown in the illustration
each time the
key is pressed. (The
key changes the order in the
opposite direction.)
3
Place the material to be sewn under the work clamps, and then press the work clamp switch (6).
The work clamps will be lowered.
4
Press the start switch (7).
The feed base will move to the sewing start position.
NOTE:
If cutting operation is set to “Cutting before sewing”, the
hammer will operate.
0225B
0433B
(2)
(1)
(5)
(4)
(3)
(2)
0413B
Independent program
(Refer to P. 39)
Cycle program
(Refer to P. 57)
0337B
0225B
(6)
0531B
(7)
0532B
