4. PREPARATION BEFORE SEWING
RH-9820
33
4-4. Threading the gimp
When threading the gimp, first remove the work clamp plates, and then thread the gimp correctly as shown in the illustration
below. Once threading has been completed, install the work clamp plates. (Refer to “3-19. Installing and removing the work
clamp plates”.)
*
The illustration below shows the method when the cotton stand is installed on the left side. If the cotton stand is installed on
the right side, the threading method will be different. Before threading, refer to “4-5. Threading the threads when the cotton
stand is installed on the right side”.
*
-
in the illustration show the positions for inserting the threader. (Refer to “4-2. Threading the upper thread” for
details on using the threader.)
Gimp should
not be clamped
<-00 specifications>
Gimp should be clamped
Gimp should
not be clamped
<-01 specifications>
Gimp should be
clamped
<-02 specifications>
0402B
(when using a
thicker gimp)
(when using about
#8 spun thread or
finer as the gimp)
