3. INSTALLATION
RH-9820
16
3-13. Installing the hand start switch (when using the hand start switch)
(1) Hand start switch
(2) Screws [2 pcs.]
(3) Cord holders [3 pcs.]
(4) Screws [3 pcs.]
* When setting up on top of the table, use only two of the
cord holders (3) and screws (4).
Pass the cord of the hand start switch (1) through the table
hole (5), and pass the connector into the control box through
the hole in the rear of the control box. (Refer to “3-8. Installing
the operation panel”.)
[When setting up on top of the table]
Insert the cord into the quick tube (6), and then pass it
through the table hole (5).
* This is to prevent damage from the cord rubbing against
the table hole (5) when the machine head is tilted back
and returned.
[When setting up on top of the table]
<Hand start switch operation method>
When the work clamp switch (left side) is depressed, the
work clamp will be lowered, and when the start switch (right
side) is depressed, the sewing machine will start.
Start switch
Work clamp switch
[When embedding into the table]
(Continued on next page)
0362B
0363B
0385B
0364B
