5. USING THE SEWING MACHINE (OPERATION PANEL: BASIC OPERATION)
RH-9820
46
5-4. Checking the sewing pattern in test mode
Test mode can be used to make only the feed base move in the same way as during normal sewing, but with the upper shaft stopped. This
mode is useful for checking the positions of the needle and other parts and of the other parts relative to each other.
1
Switch the mode to test mode.
The sewing shape (1), program number (2), total number of stitches (3) and number
of remaining stitches (4) will appear in the display.
2
Select the desired program number (2).
The program No. (2) changes in the order shown in the illustration each time the
key is pressed. (The
key changes the order in the opposite direction.)
3
Press the work clamp switch (5).
The work clamps will be lowered.
4
Press the start switch (6).
The feed base will move to the sewing start position.
5
Press the start switch (6) or the
switch to start test feeding.
(The feed base will move forward by 2 stitches each time the
switch or key is pressed.)
(The feed base will move quicker if you keep the switch or key
pressed down.)
•
The number of remaining stitches (4) on the display
will decrease by 2 each time.
•
When the final stitch is reached, the buzzer will
sound.
•
Thread trimming and cutting operation will not be
carried out in test mode.
(Continued on next page)
0230B
0410B
(2)
(1)
(4)
(3)
(2)
0337B 0230B
0413B
Independent program
(Refer to P. 39)
Cycle program
(Refer to P. 57)
0419B
0420B
(4)
0231B
0421B
