7. USING THE SEWING MACHINE (OPERATION PANEL: ADVENCED OPERATION)
RH-9820
57
7. USING THE SEWING MACHINE (OPERATION
PANEL: ADVANCED OPERATION)
7-1. Using cycle programs
The sewing patterns which have been registered in independent programs (P01 - P20) can be combined to register “cycle
programs” so that they can be run continuously. When sewing the sewing patterns in a certain order, it can be useful to record
them in a cycle program beforehand.
Cycle programs
Max. no. of recordable programs
9 (C1 - C9)
Max. no. of steps
9 (the same independent program can be selected several times)
Program example
The following shows an example of storing a cycle program into cycle program C1 that consists of three steps of independent
program 01 with cutting operation on, and one step of independent program 03 with cutting operation off.
Example: Setting contents for cycle program C1
Step number
Step 1
Step 2
Step 3
Step 4
Independent program
number
P01 P01 P01 P03
Cutting operation
Yes
Yes
Yes
No
1
Press one of the following keys to select a sewing
mode.
(In this example, automatic mode is selected.)
2
Select cycle program number C1 (1).
The program number (1) changes in the order shown in the illustration
each time the
key is pressed. The
key changes the order in the
opposite direction.
NOTE:
Cycle program mode is not available if an independent program has been
selected.
0445B
0222B
0337B
0307B
Independent program
(Refer to P. 39)
Cycle program
(1)
0413B
