5-26
Confidential
■
Change of the transfer current setting (Only for Japanese hagaki printing)
<Function>
Dots appeared when hagaki printing is performed can be alleviated by changing the transfer
current setting.
<Operating procedure>
Model without touch panel
Model with touch panel
(1) Press the
or
key to display
“MAINTENANCE 45” on the LCD in the
initial state of the maintenance mode.
Then, press the
OK
key. “USBNo.” is
displayed on the LCD.
(2) Press the
or
key to display
“Special Printing” and then press the
OK
or
Go
key. “Default” is displayed on
the LCD.
(3) Press the
or
key to change the
setting, and press the
OK
or
Go
key.
There are four setting options:
“Default”, “HAGAKI1”, “HAGAKI2”, and
“HAGAKI3”. (“*” is displayed at the end
of the currently specified function in the
LCD display. The initial value is
“Default”.)
(4) “Accepted” is displayed on the LCD,
and the machine returns to the initial
state of the maintenance mode.
(5) Perform hagaki printing again to check
if the dot symptom is alleviated.
(6) If not, repeat the steps (1) to (4) to set
an optimum option, and then perform
hagaki printing.
(1) Press the
4
and
5
keys in this order in
the initial state of the maintenance
mode. “USBNo.” is displayed on the
LCD.
(2) Press the
or
key to display
“Special Printing” and then press the
Mono
or
SET
key. “Default” is
displayed on the LCD.
(3) Press the
or
key to change the
setting, and press the
Mono
or
SET
key. There are four setting options:
“Default”, “HAGAKI1”, “HAGAKI2”, and
“HAGAKI3”. (“*” is displayed at the end
of the currently specified function in the
LCD display. The initial value is
“Default”.)
(4) “Accepted” is displayed on the LCD,
and the machine returns to the initial
state of the maintenance mode.
(5) Perform hagaki printing again to check
if the dot symptom is alleviated.
(6) If not, repeat the steps (1) to (4) to set
an optimum option, and then perform
hagaki printing.
