Brother DCP-L3510CDW, Service Manual

Page: 338 / 430

5-10
Confidential
< Operating Procedure >
(1) For models with touch panel
Press the [1], and then the [0] in the initial state of maintenance mode. “WSW00” is
displayed on the LCD.
For models without touch panel
Press the [ ▲ ] or [ ▼ ] in the initial state of maintenance mode to display
“MAINTENANCE 10” on the LCD, and press the [OK]. “WSW00” is displayed on the
LCD.
(2) For models with touch panel
Enter the worker switch number that you want to change the setting.
The following display appears on the LCD.
For models without touch panel
Press the [ ▲ ] or [ ▼ ] to display the worker switch number for which you want to change
the setting on the LCD and press the [OK]. The following display appears on the LCD.
(3) For models with touch panel
Press the [ ◄ ] or [ ► ] to move the cursor to the desired selector, and change the setting by
pressing the [1] or [0].
For models without touch panel
Pressing the [ ▲ ] enters “1” and pressing the [ ▼ ] enters “0”. Press the button of the
number that you want to enter to Selector No.1. The underline cursor moves to the next
digit. Use the [
▲ ] or [ ▼ ] to keep entering numbers until the Selector No.8 is entered in
the procedures from (2) to (5).
(4) When changing the setting is completed, press the [SET] or [OK]. The new selector
setting value is stored in the EEPROM, and the LCD returns to the ready state for worker
switch number entry (“WSW00”).
(5) When all switch setting is completed, press the [X] or [Stop] to return the machine to the
initial state of maintenance mode.
Note:
• To cancel operation and return to the initial state of maintenance mode, press the [X] or
[Stop].
• If there is no entry for one minute or longer on 2-digit worker switch number selection after
the first digit was entered, the machine returns to the initial state of maintenance mode
automatically.
Selector No.1 Selector No.8