install - concepts - PixMaster - switcher - CG - clips - controls - team - appendix
Broadcast Pix
V3.0
7.16.3
7.
In the lower right corner, set the
port
appropriately to an available communication
port. Use
USB
when a USB cable is plugged in or
COM1
or
COM2
when a serial
cable is plugged in. The “Not Ready” message changes to “Ready” when the port
opens without errors. If a COM port is in use by another device, like camera
control, Audio Follow will not work. You need to disable that port on the device to
make it active in Audio Follow.
7.16.3 Audio-Follow Setup
1.
Program the
On-Air
and
Off-Air
commands in the table provided. Sources 1-32
refer to the inputs on the Broadcast Pix Switcher. The first 9 sources are shown,
scroll down to reach the shifted sources (17 through 32). Each show can have its
own set of Audio-Follow commands.
Two programming options are available for each table entry; either a single
scene change
(MIDI Program Change command)
or
one or more
control
changes
(MIDI Control Change commands). You can not have both a scene
change and a control change for one entry.
Control changes may differ from manufacturer to manufacturer, so it is important
to refer to your audio mixer’s manual for a complete list. For example on a
Yamaha 01V, control numbers 1-12 effect the fader levels for channels 1-12.