Briot emotion, Operation Manual

Page: 190 / 210

Maintenance... Messages
5-189
0x1F Incompatible edger
configuration.
Drilling normal to front face
not allowed. The job you have loaded calls
for Drilling normal to front face.
In the personalisation menus,
you have excluded this
parameter.
Therefore the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, change the
personalisation of the pull-down
menus.
Select Drilling normal to front
face sub-finishing.
Load the job again.
0x20 Incompatible edger
configuration.
Drilling parallel to clamp
shaft not allowed. The job you have loaded calls
for Drilling parallel to clamp
shaft.
In the personalisation menus,
you have excluded this
parameter.
Therefore the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, change the
personalisation of the pull-down
menus.
Select Drilling parallel to clamp
shaft.
Load the job again.
0x21 Incompatible edger
configuration.
Front safety-bevel not
allowed. The job you have loaded calls
for front safety-bevel.
In the personalisation menus,
you have excluded this
parameter.
Therefore the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, change the
personalisation of the pull-down
menus.
Select Front safety-bevel
parameter.
Load the job again.
0x22 Incompatible edger
configuration.
Rear safety-bevel not
allowed. The job you have loaded calls
for rear safety-bevel.
In the personalisation menus,
you have excluded this
parameter.
Therefore the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, change the
personalisation of the pull-down
menus.
Select Rear safety-bevel
parameter.
Load the job again.
0x23 Incompatible edger
configuration.
Front and rear safety-bevel
not allowed. The job you have loaded calls
for front and rear safety-bevels.
In the personalisation menus,
you have excluded this
parameter.
Therefore the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, change the
personalisation of the pull-down
menus.
Select Front and rear safety-
bevel parameter.
Load the job again.
0x24 Incompatible edger
configuration.
Lens without safety-bevel
not allowed. The job you have loaded has the
No safety-bevel parameter.
In the personalisation menus,
you have excluded this
parameter.
Therefore the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, change the
personalisation of the pull-down
menus.
Select the No safety-bevel
parameter.
Load the job again.
# Message
Condition(s) for
display
Action(s)