Briot emotion, Operation Manual

Page: 187 / 210

Maintenance... Messages
5-186
0xB Incompatible edger
configuration.
HI lens not allowed. The job you have loaded calls
for High Index (HI) lens
material.
In the personalisation menus,
you have excluded this
parameter.
Therefore the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, change the
personalisation of the pull-down
menus.
Select High Index (HI) lens
material.
Load the job again.
0xC Incompatible edger
configuration.
Mineral lens not allowed. The job you have loaded calls
for Mineral lens material.
In the personalisation menus,
you have excluded this
parameter.
Therefore the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, change the
personalisation of the pull-down
menus.
Select Mineral lens material.
Load the job again.
0xD Incompatible edger
configuration.
Organic lens not allowed. The job you have loaded calls
for CR39 lens material.
In the personalisation menus,
you have excluded this
parameter.
Therefore the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, change the
personalisation of the pull-down
menus.
Select CR39 lens material.
Load the job again.
0xE Incompatible edger
configuration.
Polycarbonate lens not
allowed. The job you have loaded calls
for Polycarbonate lens material.
In the personalisation menus,
you have excluded this
parameter.
Therefore the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, change the
personalisation of the pull-down
menus.
Select Polycarbonate lens
material.
Load the job again.
0xF Incompatible edger
configuration.
Bevel finishing not allowed. The job you have loaded calls
for Bevel finishing.
In the personalisation menus,
you have excluded this
parameter.
Therefore the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, change the
personalisation of the pull-down
menus.
Select Bevel finishing.
Load the job again.
0x10 Incompatible edger
configuration.
Rimless finishing not
allowed. The job you have loaded calls
for Rimless finishing.
In the personalisation menus,
you have excluded this
parameter.
Therefore the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, change the
personalisation of the pull-down
menus.
Select Rimless finishing.
Load the job again.
0x11 Incompatible edger
configuration.
Groove finishing not
allowed. The job you have loaded calls
for Groove finishing.
In the personalisation menus,
you have excluded this
parameter.
Therefore the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, change the
personalisation of the pull-down
menus.
Select Groove finishing.
Load the job again.
# Message
Condition(s) for
display
Action(s)