Briot emotion, Operation Manual

Page: 144 / 210

Maintenance... Regular maintenance of the edger
5-143
Flow chart 5-6: Complete cleaning of the settling tank
5.7.6.3 H
INTS
>
If the pump is not activated when you restart the machine after cleaning, open the discharge valve to the
minimum to allow the escape of any air which has remained in the pipes. Close the valve before restarting
the process.
>
Always check the water-tightness of the unit before restarting the machine.
• Check the connections of the drain, water supply and pump pipes.
• Ensure that the discharge valve is closed.
• If you have worked on the solenoid valves, check the fixings.
#9 Remove the settler carefully.
#10 Clean the settler with a plastic spatula and a brush above the drainage
system (bucket, waste bin, drain, etc.).
#11 Clean the settler.
#12 Remove the used plastic bag from the settling tank and dispose of it.
#13 Clean the settling tank if necessary.
#14 Place a new plastic bag in the settling tank.
#15 Reassemble the tanks, pump and pipes.
#16 Fill the water tank to within 6 or 7 cm of the upper edge of the plastic bag.
#17 Run a dummy edging cycle to prime the unit.