GB
m
This tool is intended to be used for fastening wood
to wood in pallet/crate (-1-E / -2-E / -6-E) and construction
applications (-2-E / -6-E). DO NOT USE for fastening harder
materials which could cause buckling of the fasteners and
damage to the tool. If you are unsure of the suitability of
this tool for certain applications, please contact your local
sales office.
LOADING THE TOOL
m
Warning!
When loading the tool 1) Never place a
hand or any part of the body in fastener discharge area
of the tool; 2) Never point the tool at self or anyone else;
3) Do not pull the trigger or depress the safety yoke as
accidental actuation may occur, possibly causing injury.
1. Move the pusher to rear until latched. Cover will open.
Pusher front will drop into notch on top of magazine
rail. (Fig 1)
2. Drop staple stick over magzine and slide forward.
Repeat until magazine is loaded, allowing enough space
for pusher to disengage the magazine and the cover to
close (approximately 13mm.) (Fig 2)
3. Pull Pusher back slightly and depress pin detents. Allow
pusher to slide forward over the pin detent. (Fig 3)
Note:
Use only fasteners recommended by
Bostitch for use in Bostitch tools which meet
Bostitch specifications.
TRIP OPERATION MODE
THESE TOOLS ARE FITTED WITH 2 DIFFFERENT ACTUATION
MODES DEPENDING ON THE MODEL.
m
WARNING! Always disconnect air supply before making
adjustments as accidental actuation may occur, possibly
causing injury.
SEQUENTIAL ACTUATION MODE:
Models: S2638-2-E, S2650-2-E
•
These tools are fitted with sequential actuation (see
below). The tools also come supplied with a conversion
kit to convert them to contact actuation. If the kit is
fitted, the model will change from a -2-E to a -1-E.
•
The kit includes a new CE label for the tool with the
-1-E code. This label
MUST
be fitted to the tool if the
conversion kit is installed.
•
This conversion kit must only be fitted by authorized
agents of BOSTITCH or by other experts. Once installed,
users must follow the instructions for contact actuation
(see below).
m
Warning!
• IMPORTANT SAFETY INFORMATION ENCLOSED.
• READ THIS MANUAL BEFORE OPERATING THE TOOL.
• SAVE FOR FUTURE REFERENCE.
• FAILURE TO OBSERVE THE FOLLOWING
WARNINGS COULD RESULT IN INJURY.
• Do not use damaged, frayed or
deteriorated air hoses and fittings.
• Air powered tools can vibrate in use.
Vibration, repetitive motions or
uncomfortable positions may be harmful
to your hands and arms. Stop using any
machine if discomfort, tingling feeling
or pain occurs. Seek medical advice
before resuming use.
• Do not carry the tool by the hose.
• Keep body stance balanced and firm.
Do not overreach when operating this tool.
• Always turn off the air supply and
disconnect the air supply hose before
installing, removing or adjusting any
accessory on this tool, or before
performing any maintenance on this tool.
• Use protective equipment such as
glasses, gloves, safety shoes as well
as acoustic protection. Remain vigilant,
use common sense and pay attention
when using the machine.
• Always wear suitable CE marked
eye protection when operating or
performing maintenance on this tool.
MAX
PSI
• Operate at no more than the tool’s
maximum pressure stated in column
“I” of the technical data table.
• Do not over-oil and do not use heavy
grade oil as stalling and low
performance may result.
6