AutoDome Easy II
| en
127
Bosch Security Systems, Inc.
Installation Manual
F.01U.164.478 | 2.0 | 2010.02
Setting FastAddress with a Pelco Keyboard
1.
Press and hold
95-PRESET
for two seconds to open the
Pelco Setup menu.
2.
Move the joystick to select the
Command Lock
menu.
3.
Press the
FOCUS
or the
IRIS
button to turn Command
Lock to
OFF
.
4.
Move to the
FastAddress
menu and press the
FOCUS
or
the
IRIS
button to open the menu.
5.
Use the joystick to enter the unique identifier for the
AutoDome Easy II.
–
Move the joystick up or down to select the number.
–
Move the joystick right to move to the next number
position.
6.
Move the joystick right to select Continue. Then, press the
FOCUS
or the
IRIS
button.
7.
Use the keyboard to enter the
FastAddress
number. Then,
press the
Camera
button.
Note: You must first clear an assigned FastAddress number
to use the number for a different AutoDome Easy II.
8.
Move the joystick down then back up to set the
FastAddress
number.
9.
Press the
FOCUS
or the
IRIS
button to store the
FastAddress
number.
The on-screen display menu confirms that the AutoDome
Easy II stored the FastAddress number.
A.2
Pelco Protocol Mode
The Pelco Mode features Auto Baud Detection that
automatically detects and adjusts the AutoDome Easy II
protocol and baud rate to match that of the controller. The
AutoDome Easy II responds to Pelco-D or Pelco-P protocol
commands.
NOTICE!
The AutoDome Easy II supports only the RS-485 protocol while
in Pelco mode. It does not transmit responses back to the
controller.
