46
en | Installing a Recessed Mount
AutoDome Easy II
F.01U.164.478 | 2.0 | 2010.02
Installation Manual
Bosch Security Systems, Inc.
8.
Tighten both clamps to the ceiling using supplied screws
and a #2 Phillips screwdriver.
Figure 6.5
Tighten Mounting Clamps
6.1.3
Installing the Camera to the Mounting Plate
To install the base to a surface or suspended ceiling using the
supplied mounting plate, do the following:
1.
Use supplied T-10 key to loosen (do not completely
remove) the three (3) screws on dome bubble. Remove
trim ring and set aside.
2.
Re-tighten screws.
3.
Route wires on side of mounting plate with crescent
shaped cut-out (Ref. #4 Figure 1.2).
4.
Attach grounding wire from unit to the mounting bracket.
5.
Attach user supplied ground to junction box.
NOTICE!
Over torquing the ceiling clamps can damage the clamp or
ceiling. Only tighten the clamp until it contacts the ceiling and
you start to feel some resistance. If using a power screwdriver,
set the torque level to the lowest setting.
CAUTION!
All wires for installation applications must be routed through a
grounded conduit.
