68
en | Preparing the Wiring
AutoDome Easy II
F.01U.164.478 | 2.0 | 2010.02
Installation Manual
Bosch Security Systems, Inc.
8.5.3
Daisy Chaining
In a daisy chain configuration, where multiple domes are
connected, the resistor must be removed for all but the last
dome. The AutoDome Easy II can be daisy chained up to a
maximum of four (4) domes. To daisy chain the unit, do the
following prior to mounting the camera:
1.
Remove the 100 ohm resistor by cutting both leads from
all but the last dome.
2.
Locate the cable assembly on the first camera with a seven
(7) pin white mating connector on one end and the seven
(7) flying leads on the other end.
3.
Connect the biphase (+) from the controller to the first
camera yellow lead and secure.
4.
Connect the biphase (-) from the controller to the white/
green lead on the first camera and secure.
5.
Connect the biphase (+) from the first camera yellow lead
to the second camera yellow lead and secure.
6.
Connect the biphase (-) from the first camera white/green
lead to the second camera white/green lead and secure.
7.
Repeat steps as required for up to four (4) cameras.
