AutoDome Easy II
Getting Started | en
75
Bosch Security Systems, Inc.
Installation Manual
F.01U.164.478 | 2.0 | 2010.02
10
Getting Started
Once the installation is complete, the AutoDome Easy II can be
programmed. A typical system includes a keyboard, matrix
switcher, monitor, and appropriate wiring connections. Please
refer to the individual product manuals for complete installation
and setup instructions for each of the system components.
10.1
Powering On
When you turn the AutoDome Easy II power on there is a ten
(10) second pause before the dome starts its homing phase.
During the homing phase the camera pans left and right and
tilts up and down. It also adjusts the lens focus. The entire
homing phase lasts approximately 20 seconds and ends with a
splash screen.
10.2
Establishing AutoDome Easy II Control
The most common ways to interface with the AutoDome Easy II
are:
–
Using a keyboard and on-screen display (OSD) menus. This
method is the most common and is covered in this manual
(see
Section 8.5.2 Direct Control, page 67
).
–
Using the AutoDome Easy II Configuration Tool software
running on a PC with Bilinx communication protocol. Refer
to the CTFID User Guide for instructions.
–
Using a Digital Video Recorder (DVR) such as the Bosch
Divar XF version 2.00 or higher.
WARNING!
Before powering the dome on, remove the clear protective
plastic sheet on top of the bubble.
